| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
fou: remove warn in gue_gro_receive on unsupported protocol
Drop the WARN_ON_ONCE inn gue_gro_receive if the encapsulated type is
not known or does not have a GRO handler.
Such a packet is easily constructed. Syzbot generates them and sets
off this warning.
Remove the warning as it is expected and not actionable.
The warning was previously reduced from WARN_ON to WARN_ON_ONCE in
commit 270136613bf7 ("fou: Do WARN_ON_ONCE in gue_gro_receive for bad
proto callbacks"). |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: nl80211: disallow setting special AP channel widths
Setting the AP channel width is meant for use with the normal
20/40/... MHz channel width progression, and switching around
in S1G or narrow channels isn't supported. Disallow that. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: qla2xxx: Fix for possible memory corruption
Init Control Block is dereferenced incorrectly. Correctly dereference ICB |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ecdh - explicitly zeroize private_key
private_key is overwritten with the key parameter passed in by the
caller (if present), or alternatively a newly generated private key.
However, it is possible that the caller provides a key (or the newly
generated key) which is shorter than the previous key. In that
scenario, some key material from the previous key would not be
overwritten. The easiest solution is to explicitly zeroize the entire
private_key array first.
Note that this patch slightly changes the behavior of this function:
previously, if the ecc_gen_privkey failed, the old private_key would
remain. Now, the private_key is always zeroized. This behavior is
consistent with the case where params.key is set and ecc_is_key_valid
fails. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: emux: improve patch ioctl data validation
In load_data(), make the validation of and skipping over the main info
block match that in load_guspatch().
In load_guspatch(), add checking that the specified patch length matches
the actually supplied data, like load_data() already did. |
| In the Linux kernel, the following vulnerability has been resolved:
ibmvnic: Add tx check to prevent skb leak
Below is a summary of how the driver stores a reference to an skb during
transmit:
tx_buff[free_map[consumer_index]]->skb = new_skb;
free_map[consumer_index] = IBMVNIC_INVALID_MAP;
consumer_index ++;
Where variable data looks like this:
free_map == [4, IBMVNIC_INVALID_MAP, IBMVNIC_INVALID_MAP, 0, 3]
consumer_index^
tx_buff == [skb=null, skb=<ptr>, skb=<ptr>, skb=null, skb=null]
The driver has checks to ensure that free_map[consumer_index] pointed to
a valid index but there was no check to ensure that this index pointed
to an unused/null skb address. So, if, by some chance, our free_map and
tx_buff lists become out of sync then we were previously risking an
skb memory leak. This could then cause tcp congestion control to stop
sending packets, eventually leading to ETIMEDOUT.
Therefore, add a conditional to ensure that the skb address is null. If
not then warn the user (because this is still a bug that should be
patched) and free the old pointer to prevent memleak/tcp problems. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: check bo_va->bo is non-NULL before using it
The call to radeon_vm_clear_freed might clear bo_va->bo, so
we have to check it before dereferencing it. |
| In the Linux kernel, the following vulnerability has been resolved:
jfs: don't walk off the end of ealist
Add a check before visiting the members of ea to
make sure each ea stays within the ealist. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: strict bound check before memcmp in ocfs2_xattr_find_entry()
xattr in ocfs2 maybe 'non-indexed', which saved with additional space
requested. It's better to check if the memory is out of bound before
memcmp, although this possibility mainly comes from crafted poisonous
images. |
| In the Linux kernel, the following vulnerability has been resolved:
uio_hv_generic: Don't free decrypted memory
In CoCo VMs it is possible for the untrusted host to cause
set_memory_encrypted() or set_memory_decrypted() to fail such that an
error is returned and the resulting memory is shared. Callers need to
take care to handle these errors to avoid returning decrypted (shared)
memory to the page allocator, which could lead to functional or security
issues.
The VMBus device UIO driver could free decrypted/shared pages if
set_memory_decrypted() fails. Check the decrypted field in the gpadl
to decide whether to free the memory. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: send: handle path ref underflow in header iterate_inode_ref()
Change BUG_ON to proper error handling if building the path buffer
fails. The pointers are not printed so we don't accidentally leak kernel
addresses. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/mm: Disallow vsyscall page read for copy_from_kernel_nofault()
When trying to use copy_from_kernel_nofault() to read vsyscall page
through a bpf program, the following oops was reported:
BUG: unable to handle page fault for address: ffffffffff600000
#PF: supervisor read access in kernel mode
#PF: error_code(0x0000) - not-present page
PGD 3231067 P4D 3231067 PUD 3233067 PMD 3235067 PTE 0
Oops: 0000 [#1] PREEMPT SMP PTI
CPU: 1 PID: 20390 Comm: test_progs ...... 6.7.0+ #58
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996) ......
RIP: 0010:copy_from_kernel_nofault+0x6f/0x110
......
Call Trace:
<TASK>
? copy_from_kernel_nofault+0x6f/0x110
bpf_probe_read_kernel+0x1d/0x50
bpf_prog_2061065e56845f08_do_probe_read+0x51/0x8d
trace_call_bpf+0xc5/0x1c0
perf_call_bpf_enter.isra.0+0x69/0xb0
perf_syscall_enter+0x13e/0x200
syscall_trace_enter+0x188/0x1c0
do_syscall_64+0xb5/0xe0
entry_SYSCALL_64_after_hwframe+0x6e/0x76
</TASK>
......
---[ end trace 0000000000000000 ]---
The oops is triggered when:
1) A bpf program uses bpf_probe_read_kernel() to read from the vsyscall
page and invokes copy_from_kernel_nofault() which in turn calls
__get_user_asm().
2) Because the vsyscall page address is not readable from kernel space,
a page fault exception is triggered accordingly.
3) handle_page_fault() considers the vsyscall page address as a user
space address instead of a kernel space address. This results in the
fix-up setup by bpf not being applied and a page_fault_oops() is invoked
due to SMAP.
Considering handle_page_fault() has already considered the vsyscall page
address as a userspace address, fix the problem by disallowing vsyscall
page read for copy_from_kernel_nofault(). |
| In the Linux kernel, the following vulnerability has been resolved:
media: rc: bpf attach/detach requires write permission
Note that bpf attach/detach also requires CAP_NET_ADMIN. |
| In the Linux kernel, the following vulnerability has been resolved:
um: time-travel: fix time corruption
In 'basic' time-travel mode (without =inf-cpu or =ext), we
still get timer interrupts. These can happen at arbitrary
points in time, i.e. while in timer_read(), which pushes
time forward just a little bit. Then, if we happen to get
the interrupt after calculating the new time to push to,
but before actually finishing that, the interrupt will set
the time to a value that's incompatible with the forward,
and we'll crash because time goes backwards when we do the
forwarding.
Fix this by reading the time_travel_time, calculating the
adjustment, and doing the adjustment all with interrupts
disabled. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: switchtec: Fix stdev_release() crash after surprise hot remove
A PCI device hot removal may occur while stdev->cdev is held open. The call
to stdev_release() then happens during close or exit, at a point way past
switchtec_pci_remove(). Otherwise the last ref would vanish with the
trailing put_device(), just before return.
At that later point in time, the devm cleanup has already removed the
stdev->mmio_mrpc mapping. Also, the stdev->pdev reference was not a counted
one. Therefore, in DMA mode, the iowrite32() in stdev_release() will cause
a fatal page fault, and the subsequent dma_free_coherent(), if reached,
would pass a stale &stdev->pdev->dev pointer.
Fix by moving MRPC DMA shutdown into switchtec_pci_remove(), after
stdev_kill(). Counting the stdev->pdev ref is now optional, but may prevent
future accidents.
Reproducible via the script at
https://lore.kernel.org/r/20231113212150.96410-1-dns@arista.com |
| In the Linux kernel, the following vulnerability has been resolved:
s390/ptrace: handle setting of fpc register correctly
If the content of the floating point control (fpc) register of a traced
process is modified with the ptrace interface the new value is tested for
validity by temporarily loading it into the fpc register.
This may lead to corruption of the fpc register of the tracing process:
if an interrupt happens while the value is temporarily loaded into the
fpc register, and within interrupt context floating point or vector
registers are used, the current fp/vx registers are saved with
save_fpu_regs() assuming they belong to user space and will be loaded into
fp/vx registers when returning to user space.
test_fp_ctl() restores the original user space fpc register value, however
it will be discarded, when returning to user space.
In result the tracer will incorrectly continue to run with the value that
was supposed to be used for the traced process.
Fix this by saving fpu register contents with save_fpu_regs() before using
test_fp_ctl(). |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rt2x00: restart beacon queue when hardware reset
When a hardware reset is triggered, all registers are reset, so all
queues are forced to stop in hardware interface. However, mac80211
will not automatically stop the queue. If we don't manually stop the
beacon queue, the queue will be deadlocked and unable to start again.
This patch fixes the issue where Apple devices cannot connect to the
AP after calling ieee80211_restart_hw(). |
| In the Linux kernel, the following vulnerability has been resolved:
spi: sun6i: reduce DMA RX transfer width to single byte
Through empirical testing it has been determined that sometimes RX SPI
transfers with DMA enabled return corrupted data. This is down to single
or even multiple bytes lost during DMA transfer from SPI peripheral to
memory. It seems the RX FIFO within the SPI peripheral can become
confused when performing bus read accesses wider than a single byte to it
during an active SPI transfer.
This patch reduces the width of individual DMA read accesses to the
RX FIFO to a single byte to mitigate that issue. |
| Umbraco is an ASP.NET CMS. Due to unsafe handling and deletion of temporary files in versions 10.0.0 through 13.12.0, during the dictionary upload process an attacker with access to the backoffice can trigger predictable requests to temporary file paths. The application’s error responses (HTTP 500 when a file exists, 404 when it does not) allow the attacker to enumerate the existence of arbitrary files on the server’s filesystem. This vulnerability does not allow reading or writing file contents. In certain configurations, incomplete clean-up of temporary upload files may additionally expose the NTLM hash of the Windows account running the Umbraco application. This issue is fixed in version 13.12.1. |
| XiangShan Nanhu V2 and XiangShan Kunmighu V3 were discovered to use speculative execution and indirect branch prediction, allowing attackers to access sensitive information via side-channel analysis of the data cache. |
