| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bus: mhi: host: Fix race between unprepare and queue_buf
A client driver may use mhi_unprepare_from_transfer() to quiesce
incoming data during the client driver's tear down. The client driver
might also be processing data at the same time, resulting in a call to
mhi_queue_buf() which will invoke mhi_gen_tre(). If mhi_gen_tre() runs
after mhi_unprepare_from_transfer() has torn down the channel, a panic
will occur due to an invalid dereference leading to a page fault.
This occurs because mhi_gen_tre() does not verify the channel state
after locking it. Fix this by having mhi_gen_tre() confirm the channel
state is valid, or return error to avoid accessing deinitialized data.
[mani: added stable tag] |
| In the Linux kernel, the following vulnerability has been resolved:
HID: appleir: fix UAF on pending key_up_timer in remove()
appleir_remove() runs hid_hw_stop() before timer_delete_sync().
hid_hw_stop() synchronously unregisters the HID input device via
hid_disconnect() -> hidinput_disconnect() -> input_unregister_device(),
which drops the last reference and frees the underlying input_dev when
no userspace handle holds it open.
key_up_tick() reads appleir->input_dev and calls input_report_key() /
input_sync() on it. The timer is armed from appleir_raw_event() with
a HZ/8 (~125 ms) timeout on every keydown and key-repeat report. If a
key was pressed shortly before the device is disconnected, the timer
can fire after hid_hw_stop() has freed input_dev but before the
teardown drains it.
A simple reorder is not sufficient. Putting the timer drain first
still leaves a window where a USB URB completion (raw_event) running
during hid_hw_stop() can call mod_timer() and re-arm the timer, which
then fires after hidinput_disconnect() has freed input_dev. The same
URB-completion window also lets raw_event() reach key_up(), key_down()
and battery_flat() directly, all of which dereference
appleir->input_dev.
Introduce a 'removing' flag on struct appleir, gated by the existing
spinlock. appleir_remove() sets the flag under the lock and then
shuts down the timer with timer_shutdown_sync(), which both drains any
in-flight callback and permanently disables further mod_timer() calls.
appleir_raw_event() and key_up_tick() bail out early if the flag is
set, so no path can arm or run the timer, or dereference
appleir->input_dev, after remove() has started tearing down.
The keyrepeat and flatbattery branches of appleir_raw_event()
previously called into the input layer without holding the spinlock;
take it now so the flag check is well-defined. This incidentally
closes a pre-existing read-side race on appleir->current_key in the
keyrepeat branch.
This bug is structurally a sibling of commit 4db2af929279 ("HID:
appletb-kbd: fix UAF in inactivity-timer cleanup path") and has been
present since the driver was introduced. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_api: use RCU with deferred freeing for action lifecycle
When NEWTFILTER and DELFILTER are run concurrently it is possible to create a
race with an associated action.
Let's illustrate with CPU0 running NEWTFILTER and CPU1 running DELFILTER:
0: mutex_lock() <-- holds the idr lock
0: rcu_read_lock()
0: p = idr_find(idr, index) <-- action p is valid (RCU protects IDR)
0: mutex_unlock() <-- releases the idr lock
1: refcount_dec_and_mutex_lock() <-- refcnt 1->0, mutex held
1: idr_remove(idr, index) <-- Action removed from IDR
1: mutex_unlock() <-- mutex released allowing us to delete the action
1: tcf_action_cleanup(p); kfree(p) <-- Kfrees p immediately, no deferral
0: refcount_inc_not_zero(&p->tcfa_refcnt) <-- ouch, UAF p points to freed memory
This patch fixes the race condition between NEWTFILTER and DELFILTER by
adding struct rcu_head to tc_action used in the deferral and introducing a
call_rcu() in the delete path to defer the final kfree().
Note: this is a revert of commit d7fb60b9cafb ("net_sched: get rid of tcfa_rcu")
but also modernization/simplification to directly use kfree_rcu().
Let's illustrate the new restored code path:
0: rcu_read_lock()
1: refcount_dec_and_mutex_lock() <-- refcnt 1->0, mutex held
1: idr_remove(idr, index)
1: mutex_unlock()
1: call_rcu(&p->tcfa_rcu, tcf_action_rcu_free) <-- defer kfree after grace period
0: p = idr_find(idr, index)
0: refcount_inc_not_zero(&p->tcfa_refcnt) <-- fails, refcnt already 0
1: rcu_read_unlock() <-- release so freeing can run after grace period
After CPU1 calls idr_remove(), the object is no longer reachable through the IDR.
CPU0's subsequent idr_find() will return NULL, and even if it still held a
stale pointer, the immediate kfree() is now deferred until after the RCU grace
period, so no UAF can occur. |
| datamodel-code-generator generates Pydantic v2 models, dataclasses, TypedDict, and msgspec.Struct from OpenAPI, JSON Schema, GraphQL, Avro, Protobuf, and raw JSON, YAML, or CSV. Prior to 0.63.0, datamodel-code-generator validates a URL host once in src/datamodel_code_generator/http.py through get_body, _validate_url_for_fetch, and _get_ips_from_host, but then lets httpx resolve the host again for the connection, allowing DNS rebinding to bypass allow_private_network=False and reach internal services. This issue is fixed in version 0.63.0. |
| When grant-copy operations are processed, the respective grant may or may
not already be in use by another operation (a mapping or another copy).
For all copy operations the referenced guest frame is looked up. When
another operation is already active for the grant (the grant is "pinned"),
what is being supplied back to actually carry out permission checks and
copy operation may not be consistent: The permission check may be carried
out on a page different from the one involved in the copy. |
| [This CNA information record relates to multiple CVEs; the
text explains which aspects/vulnerabilities correspond to which CVE.]
With the introduction of Grant Table v2 came the requirement to be able to
switch between versions. Switching from v1 to v2 reduces the number of
valid grant references, as a bigger shared entry structure is then needed
while the shared table doesn't change size. Switching from v2 back to v1
the status frames, which are separate in v2, go away.
Code holding, but intermediately dropping and then re-acquiring the grant
table lock, sometimes wrongly assumes that said properties wouldn't change
across the window in time where the lock is not being held.
The v1 -> v2 issue is CVE-2026-62435.
The v2 -> v1 issue is CVE-2026-62436. |
| The EVTCHNOP_expand_array hypercall checks for whether FIFO event
channels are enabled, but without holding the correct lock. It can race
with EVTCHNOP_reset, resulting in dereferencing a NULL pointer. |
| In Progress® Telerik® UI for AJAX prior to v2026.2.708, insufficient validation of the language parameter in the spell check handler may allow an attacker to influence server-side file path resolution and trigger unintended server-side requests. |
| [This CNA information record relates to multiple CVEs; the
text explains which aspects/vulnerabilities correspond to which CVE.]
With the introduction of Grant Table v2 came the requirement to be able to
switch between versions. Switching from v1 to v2 reduces the number of
valid grant references, as a bigger shared entry structure is then needed
while the shared table doesn't change size. Switching from v2 back to v1
the status frames, which are separate in v2, go away.
Code holding, but intermediately dropping and then re-acquiring the grant
table lock, sometimes wrongly assumes that said properties wouldn't change
across the window in time where the lock is not being held.
The v1 -> v2 issue is CVE-2026-62435.
The v2 -> v1 issue is CVE-2026-62436. |
| Accessing the vNUMA configuration data of a guest is still possible when
domain destruction has already started. The cleaning up of that
configuration information is not synchronized with its retrieval by a
device model controlling the guest. |
| Accesses to the CMOS memory contents are done using an indirect IO port
pair. Therefore Xen needs to cache the guest chosen index, and one of
the usages of the index didn't take the necessary locking to avoid
concurrent changes. As a result, a guest could change the index after
it being checked, causing a subsequent out-of-bound read access to the
contents of an array. |
| The logic to handle periodic Viridian STIMERs performs a division with an
unchecked user-controlled divisor value, that can be set to zero to cause a #DE
fault. |
| Race in USB in Google Chrome prior to 150.0.7871.47 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Medium) |
| SurrealDB versions before 3.1.0 contain a time-of-check/time-of-use race condition in the HTTP /rpc endpoint that allows unauthenticated requests to inherit authenticated session state. Unauthenticated attackers can send concurrent requests to the /rpc endpoint while legitimate authenticated traffic is active to execute operations with hijacked user privileges. |
| Flameshot is powerful yet simple to use screenshot software. Prior to 14.0.0, the Open With feature wrote screenshots to a predictable temporary path and followed symlinks, creating a time-of-check to time-of-use race that allowed a local unprivileged attacker on the same machine to pre-plant a symlink and cause Flameshot to write PNG data through it, overwriting any file the victim user could write. This issue is fixed in version 14.0.0. |
| RabbitMQ is a messaging and streaming broker. Prior to 4.1.11 and 4.2.6 on Windows, the RabbitMQ management plugin static file handler rabbit_mgmt_wm_static can pass URL-encoded backslashes to erl_prim_loader:read_file_info before path validation when multiple management extension plugins are enabled, causing outbound DNS and SMB requests to attacker-controlled UNC paths. This issue is fixed in versions 4.1.11 and 4.2.6. |
| In the Linux kernel, the following vulnerability has been resolved:
mptcp: close TOCTOU race while computing rcv_wnd
The MPTCP output path access locklessly the MPTCP-level ack_seq
in multiple times, using possibly different values for the data_ack
in the DSS option and to compute the announced rcv wnd for the same
packet.
Refactor the cote to avoid inconsistencies which may confuse the
peer. Also ensure that the MPTCP level rcv wnd is updated only when
the egress packet actually contains a DSS ack. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mctp: usb: fix race between urb completion and rx_retry cancellation
It's possible that sequencing between setting ->stopped and cancelling
the rx_retry work (in ndo_stop) could leave us with an urb queued:
T1: ndo_stop T2: rx_retry_work
------------ ----------------
LD: ->stopped => false
ST: ->stopped <= true
usb_kill_urb()
mctp_usb_rx_queue()
usb_submit_urb()
cancel_delayed_work_sync()
That urb completion can then re-schedule rx_retry_work.
Strenghen the sequencing between the stop (preventing another requeue)
and the cancel by updating both atomically under a new rx lock. After
setting ->rx_stopped, and cancelling pending work, we know that the
requeue cannot occur, so all that's left is killing any pending urb. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/gem: fix race between change_handle and handle_delete
drm_gem_change_handle_ioctl leaves the old handle live in the IDR
during the window between spin_unlock(table_lock) and the final
spin_lock(table_lock). A concurrent drm_gem_handle_delete on the old
handle succeeds in this window, decrements handle_count to 0, and frees
the GEM object while the new handle's IDR entry still references it.
NULL the old handle's IDR entry before dropping table_lock so that any
concurrent GEM_CLOSE on the old handle sees NULL and returns -EINVAL.
Restore the old entry on the prime-bookkeeping error path. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: adis16260: fix division by zero in write_raw
Add a validation check for the sampling frequency value before using it
as a divisor. A user writing zero to the sampling_frequency sysfs
attribute triggers a division by zero in the kernel. |
