| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
efi: Fix reservation of unaccepted memory table
The reserve_unaccepted() function incorrectly calculates the size of the
memblock reservation for the unaccepted memory table. It aligns the
size of the table, but fails to account for cases where the table's
starting physical address (efi.unaccepted) is not page-aligned.
If the table starts at an offset within a page and its end crosses into
a subsequent page that the aligned size does not cover, the end of the
table will not be reserved. This can lead to the table being overwritten
or inaccessible, causing a kernel panic in accept_memory().
This issue was observed when starting Intel TDX VMs with specific memory
sizes (e.g., > 64GB).
Fix this by calculating the end address first (including the unaligned
start) and then aligning it up, ensuring the entire range is covered
by the reservation. |
| In the Linux kernel, the following vulnerability has been resolved:
apparmor: avoid per-cpu hold underflow in aa_get_buffer
When aa_get_buffer() pulls from the per-cpu list it unconditionally
decrements cache->hold. If hold reaches 0 while count is still non-zero,
the unsigned decrement wraps to UINT_MAX. This keeps hold non-zero for a
very long time, so aa_put_buffer() never returns buffers to the global
list, which can starve other CPUs and force repeated kmalloc(aa_g_path_max)
allocations.
Guard the decrement so hold never underflows. |
| In the Linux kernel, the following vulnerability has been resolved:
xen-netback: reject zero-queue configuration from guest
A malicious or buggy Xen guest can write "0" to the xenbus key
"multi-queue-num-queues". The connect() function in the backend only
validates the upper bound (requested_num_queues > xenvif_max_queues)
but not zero, allowing requested_num_queues=0 to reach
vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers
WARN_ON_ONCE(!size) in __vmalloc_node_range().
On systems with panic_on_warn=1, this allows a guest-to-host denial
of service.
The Xen network interface specification requires
the queue count to be "greater than zero".
Add a zero check to match the validation already present
in xen-blkback, which has included this
guard since its multi-queue support was added. |
| In the Linux kernel, the following vulnerability has been resolved:
apparmor: Fix & Optimize table creation from possibly unaligned memory
Source blob may come from userspace and might be unaligned.
Try to optize the copying process by avoiding unaligned memory accesses.
- Added Fixes tag
- Added "Fix &" to description as this doesn't just optimize but fixes
a potential unaligned memory access
[jj: remove duplicate word "convert" in comment trigger checkpatch warning] |
| In the Linux kernel, the following vulnerability has been resolved:
fat: avoid parent link count underflow in rmdir
Corrupted FAT images can leave a directory inode with an incorrect
i_nlink (e.g. 2 even though subdirectories exist). rmdir then
unconditionally calls drop_nlink(dir) and can drive i_nlink to 0,
triggering the WARN_ON in drop_nlink().
Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the
parent link count when it is at least 3, otherwise report a filesystem
error. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: properly validate the data in rtw_get_ie_ex()
Just like in commit 154828bf9559 ("staging: rtl8723bs: fix out-of-bounds
read in rtw_get_ie() parser"), we don't trust the data in the frame so
we should check the length better before acting on it |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: esp: avoid in-place decrypt on shared skb frags
MSG_SPLICE_PAGES can attach pages from a pipe directly to an skb. TCP
marks such skbs with SKBFL_SHARED_FRAG after skb_splice_from_iter(),
so later paths that may modify packet data can first make a private
copy. The IPv4/IPv6 datagram append paths did not set this flag when
splicing pages into UDP skbs.
That leaves an ESP-in-UDP packet made from shared pipe pages looking
like an ordinary uncloned nonlinear skb. ESP input then takes the no-COW
fast path for uncloned skbs without a frag_list and decrypts in place
over data that is not owned privately by the skb.
Mark IPv4/IPv6 datagram splice frags with SKBFL_SHARED_FRAG, matching
TCP. Also make ESP input fall back to skb_cow_data() when the flag is
present, so ESP does not decrypt externally backed frags in place.
Private nonlinear skb frags still use the existing fast path.
This intentionally does not change ESP output. In esp_output_head(),
the path that appends the ESP trailer to existing skb tailroom without
calling skb_cow_data() is not reachable for nonlinear skbs:
skb_tailroom() returns zero when skb->data_len is nonzero, while ESP
tailen is positive. Thus ESP output will either use the separate
destination-frag path or fall back to skb_cow_data(). |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix potential out-of-bounds read in rtw_restruct_wmm_ie
The current code checks 'i + 5 < in_len' at the end of the if statement.
However, it accesses 'in_ie[i + 5]' before that check, which can lead
to an out-of-bounds read. Move the length check to the beginning of the
conditional to ensure the index is within bounds before accessing the
array. |
| In the Linux kernel, the following vulnerability has been resolved:
net: skbuff: preserve shared-frag marker during coalescing
skb_try_coalesce() can attach paged frags from @from to @to. If @from
has SKBFL_SHARED_FRAG set, the resulting @to skb can contain the same
externally-owned or page-cache-backed frags, but the shared-frag marker
is currently lost.
That breaks the invariant relied on by later in-place writers. In
particular, ESP input checks skb_has_shared_frag() before deciding
whether an uncloned nonlinear skb can skip skb_cow_data(). If TCP
receive coalescing has moved shared frags into an unmarked skb, ESP can
see skb_has_shared_frag() as false and decrypt in place over page-cache
backed frags.
Propagate SKBFL_SHARED_FRAG when skb_try_coalesce() transfers paged
frags. The tailroom copy path does not need the marker because it copies
bytes into @to's linear data rather than transferring frag descriptors. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: kaweth: validate USB endpoints
The kaweth driver should validate that the device it is probing has the
proper number and types of USB endpoints it is expecting before it binds
to it. If a malicious device were to not have the same urbs the driver
will crash later on when it blindly accesses these endpoints. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_h323: fix OOB read in decode_int() CONS case
In decode_int(), the CONS case calls get_bits(bs, 2) to read a length
value, then calls get_uint(bs, len) without checking that len bytes
remain in the buffer. The existing boundary check only validates the
2 bits for get_bits(), not the subsequent 1-4 bytes that get_uint()
reads. This allows a malformed H.323/RAS packet to cause a 1-4 byte
slab-out-of-bounds read.
Add a boundary check for len bytes after get_bits() and before
get_uint(). |
| A flaw was found in Corosync. An integer overflow vulnerability in Corosync's join message sanity validation allows a remote, unauthenticated attacker to send crafted User Datagram Protocol (UDP) packets. This can cause the service to crash, leading to a denial of service. This vulnerability specifically affects Corosync deployments configured to use totemudp/totemudpu mode. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Validate L2CAP_INFO_RSP payload length before access
l2cap_information_rsp() checks that cmd_len covers the fixed
l2cap_info_rsp header (type + result, 4 bytes) but then reads
rsp->data without verifying that the payload is present:
- L2CAP_IT_FEAT_MASK calls get_unaligned_le32(rsp->data), which reads
4 bytes past the header (needs cmd_len >= 8).
- L2CAP_IT_FIXED_CHAN reads rsp->data[0], 1 byte past the header
(needs cmd_len >= 5).
A truncated L2CAP_INFO_RSP with result == L2CAP_IR_SUCCESS triggers an
out-of-bounds read of adjacent skb data.
Guard each data access with the required payload length check. If the
payload is too short, skip the read and let the state machine complete
with safe defaults (feat_mask and remote_fixed_chan remain zero from
kzalloc), so the info timer cleanup and l2cap_conn_start() still run
and the connection is not stalled. |
| The egg-mkfont utility in Panda3D versions up to and including 1.10.16 contains an uncontrolled format string vulnerability. The -gp (glyph pattern) command-line option is used directly as the format string for sprintf() with only a single argument supplied. If an attacker provides additional format specifiers, egg-mkfont may read unintended stack values and write the formatted output into generated .egg and .png files, resulting in disclosure of stack-resident memory and pointer values. |
| The egg-mkfont utility in Panda3D versions up to and including 1.10.16 contains a stack-based buffer overflow vulnerability due to use of an unbounded sprintf() call with attacker-controlled input. When constructing glyph filenames, egg-mkfont formats a user-supplied glyph pattern (-gp) into a fixed-size stack buffer without length validation. Supplying an excessively long glyph pattern string can overflow the stack buffer, resulting in memory corruption and a deterministic crash. Depending on build configuration and execution environment, the overflow may also be exploitable for arbitrary code execution. |
| OpenLDAP Lightning Memory-Mapped Database (LMDB) versions up to and including 0.9.14, prior to commit 8e1fda8, contain a heap buffer underflow in the readline() function of mdb_load. When processing malformed input containing an embedded NUL byte, an unsigned offset calculation can underflow and cause an out-of-bounds read of one byte before the allocated heap buffer. This can cause mdb_load to crash, leading to a limited denial-of-service condition. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix potencial OOB in get_file_all_info() for compound requests
When a compound request consists of QUERY_DIRECTORY + QUERY_INFO
(FILE_ALL_INFORMATION) and the first command consumes nearly the entire
max_trans_size, get_file_all_info() would blindly call smbConvertToUTF16()
with PATH_MAX, causing out-of-bounds write beyond the response buffer.
In get_file_all_info(), there was a missing validation check for
the client-provided OutputBufferLength before copying the filename into
FileName field of the smb2_file_all_info structure.
If the filename length exceeds the available buffer space, it could lead to
potential buffer overflows or memory corruption during smbConvertToUTF16
conversion. This calculating the actual free buffer size using
smb2_calc_max_out_buf_len() and returning -EINVAL if the buffer is
insufficient and updating smbConvertToUTF16 to use the actual filename
length (clamped by PATH_MAX) to ensure a safe copy operation. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: ->d_compare() must not block
... so don't use __getname() there. Switch it (and ntfs_d_hash(), while
we are at it) to kmalloc(PATH_MAX, GFP_NOWAIT). Yes, ntfs_d_hash()
almost certainly can do with smaller allocations, but let ntfs folks
deal with that - keep the allocation size as-is for now.
Stop abusing names_cachep in ntfs, period - various uses of that thing
in there have nothing to do with pathnames; just use k[mz]alloc() and
be done with that. For now let's keep sizes as-in, but AFAICS none of
the users actually want PATH_MAX. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: validate response sizes in ipc_validate_msg()
ipc_validate_msg() computes the expected message size for each
response type by adding (or multiplying) attacker-controlled fields
from the daemon response to a fixed struct size in unsigned int
arithmetic. Three cases can overflow:
KSMBD_EVENT_RPC_REQUEST:
msg_sz = sizeof(struct ksmbd_rpc_command) + resp->payload_sz;
KSMBD_EVENT_SHARE_CONFIG_REQUEST:
msg_sz = sizeof(struct ksmbd_share_config_response) +
resp->payload_sz;
KSMBD_EVENT_LOGIN_REQUEST_EXT:
msg_sz = sizeof(struct ksmbd_login_response_ext) +
resp->ngroups * sizeof(gid_t);
resp->payload_sz is __u32 and resp->ngroups is __s32. Each addition
can wrap in unsigned int; the multiplication by sizeof(gid_t) mixes
signed and size_t, so a negative ngroups is converted to SIZE_MAX
before the multiply. A wrapped value of msg_sz that happens to
equal entry->msg_sz bypasses the size check on the next line, and
downstream consumers (smb2pdu.c:6742 memcpy using rpc_resp->payload_sz,
kmemdup in ksmbd_alloc_user using resp_ext->ngroups) then trust the
unverified length.
Use check_add_overflow() on the RPC_REQUEST and SHARE_CONFIG_REQUEST
paths to detect integer overflow without constraining functional
payload size; userspace ksmbd-tools grows NDR responses in 4096-byte
chunks for calls like NetShareEnumAll, so a hard transport cap is
unworkable on the response side. For LOGIN_REQUEST_EXT, reject
resp->ngroups outside the signed [0, NGROUPS_MAX] range up front and
report the error from ipc_validate_msg() so it fires at the IPC
boundary; with that bound the subsequent multiplication and addition
stay well below UINT_MAX. The now-redundant ngroups check and
pr_err in ksmbd_alloc_user() are removed.
This is the response-side analogue of aab98e2dbd64 ("ksmbd: fix
integer overflows on 32 bit systems"), which hardened the request
side. |
| Kitty is a cross-platform GPU based terminal. Versions 0.46.2 and below contain a heap buffer overflow in load_image_data() that allows any process which can write to the terminal's stdin to crash kitty immediately. The vulnerability is triggered by a single APC graphics protocol command with a PNG format declaration (f=100) whose payload exceeds twice the initial buffer capacity. The overflow is attacker-controlled in both length and content, causing DoS and potentially escalation to RCE itself. This issue has been fixed in version 0.47.0. |
