| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
rseq: Prevent hard lockup on granted time slice extension
__exit_to_user_mode_loop() invokes rseq_grant_timeslice_extension() with
interrupts enabled. If the extension is granted it invokes
hrtimer_rearm_deferred_tif() to ensure that a pending deferred hrtimer
rearm is handled before exiting to user space.
Though this invokes __hrtimer_rearm_deferred() which expects to be invoked
with interrupts disabled as it takes hrtimer_cpu_base::lock with
raw_spin_lock(). That's a livelock waiting to happen and caught by lockdep:
WARNING: ./include/linux/hrtimer_rearm.h:17 at irqentry_exit, CPU#1: slice_test
WARNING: inconsistent lock state
inconsistent {IN-HARDIRQ-W} -> {HARDIRQ-ON-W} usage.
Prevent this by disabling interrupts around the invocation of
hrtimer_rearm_deferred_tif() in rseq_grant_timeslice_extension().
[ tglx: Massaged change log ] |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ipset: fix refcount race between list:set GC and swap
__ip_set_put_byindex() resolved the index to a set pointer under RCU,
then took ip_set_ref_lock in __ip_set_put() to decrement set->ref.
ip_set_swap() holds that same lock while swapping both the ip_set_list
slots and the two sets' ref counters, so it can interleave between the
dereference and the lock acquisition, leaving the caller to decrement a
set whose reference already moved to the other index and hit
BUG_ON(set->ref == 0). list_set_gc() reaches this from timer softirq,
which the nfnl mutex does not serialize against swap: an expiring
list:set member calls list_set_del() -> ip_set_put_byindex() while
IPSET_CMD_SWAP runs on the referenced sets.
Resolve the index and decrement under ip_set_ref_lock, as ip_set_swap()
already does, keeping the refcount tied to the index rather than to a
stale set pointer.
kernel BUG at net/netfilter/ipset/ip_set_core.c:685!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ip_set_put_byindex (net/netfilter/ipset/ip_set_core.c:870)
Call Trace:
<IRQ>
list_set_del (net/netfilter/ipset/ip_set_list_set.c:159)
set_cleanup_entries (net/netfilter/ipset/ip_set_list_set.c:181)
list_set_gc (net/netfilter/ipset/ip_set_list_set.c:578)
call_timer_fn (kernel/time/timer.c:1748)
__run_timers (kernel/time/timer.c:1799 kernel/time/timer.c:2374)
run_timer_softirq (kernel/time/timer.c:2405)
</IRQ>
Kernel panic - not syncing: Fatal exception in interrupt |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: revalidate ihl to prevent out-of-bounds access
While the outer IP header is already pulled into the skb head,
we must be careful and revalidate the embedded headers after
reading them from the skb frags to prevent out-of-bounds
access.
One such place reported by Sashiko is ip_vs_nat_icmp() where
local process can change the ihl field and after
skb_ensure_writable() we can see larger value which is a
problem for the ip_send_check(cih) calls.
Add check to drop the packet if the ihl field is changed. |
| In the Linux kernel, the following vulnerability has been resolved:
eth: bnxt: avoid deadlock when canceling IRQ affinity notifier
Unregistering IRQ affinity notifiers waits for the callback synchronously.
bnxt takes the netdev instance lock in the notifier (to restart the queue)
and cancels the work under the same lock. This may obviously deadlock.
Move the restart to the async service task. The queue restart isn't
super time sensitive. Store the new TPH tag, schedule the task.
Safely canceling the service task is already ironed out.
In bnxt_request_irq() the order of registering notifier, affinity and
initial TPH programming has to be inverted. I think it was racy
previously since user may trigger an update as soon as notifier
is installed.
There's a small known gap - if pcie_tph_get_cpu_st() fails at init
and the target tag is 0 we may miss programming the entry.
This does not seem worth fixing, the code has skip-on-failure
all over the place, anyway. |
| In the Linux kernel, the following vulnerability has been resolved:
macvlan: inherit needed_headroom and needed_tailroom from lowerdev
macvlan devices inherit hard_header_len from lowerdev during macvlan_init(),
but leave needed_headroom and needed_tailroom set to 0.
When the underlying lowerdev requires extra headroom or tailroom for
headers/trailers (e.g. macsec, ipsec, wireguard, tunnels, or veth with rx
headroom), upper layers calculating packet headroom and tailroom fail to
reserve sufficient space.
This can result in reallocation overhead, skb headroom underflows, or KASAN
slab-use-after-free crashes when dev_hard_header() / macvlan_hard_header()
prepends header data or when lower devices append tailroom.
Fix this by:
1. Inheriting needed_headroom and needed_tailroom from lowerdev in macvlan_init().
2. Propagating needed_headroom and needed_tailroom updates to attached macvlans
in macvlan_device_event() when receiving NETDEV_FEAT_CHANGE events. |
| In the Linux kernel, the following vulnerability has been resolved:
veth: fix queue index used to wake the peer txq in veth_poll
veth_poll() derives the index of the peer TX queue to wake from
rq->xdp_rxq.queue_index. That field is only initialized by
xdp_rxq_info_reg() in veth_enable_xdp_range(), which runs only when an
XDP program is attached. On the plain GRO/NAPI path
(veth_napi_enable_range()) xdp_rxq_info_reg() is never called, so
queue_index stays 0 for every queue, as priv->rq is zero-allocated.
So in a multi-queue setup with GRO enabled and no XDP program attached,
every NAPI instance looks at the peer's TX queue 0. If veth_xmit() stops
peer TX queue 1 because the ptr_ring is full (NETDEV_TX_BUSY), nothing
ever wakes it again: the poller draining queue 1 wakes queue 0 instead.
veth implements no ndo_tx_timeout, so the netdev watchdog does not kick
in either, and the queue stays stopped indefinitely.
Derive the index from the position of the rq within priv->rq instead,
which is correct regardless of whether XDP was ever enabled.
Scripts to reproduce the stall are available at
https://github.com/netoptimizer/veth-backpressure-performance-testing |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_u32: skip hash tables in u32_bind_class()
u32_walk() enumerates both struct tc_u_hnode and struct tc_u_knode
through the walker callback. u32_bind_class() unconditionally casts the
passed fh to tc_u_knode and accesses &n->res, so when fh is actually a
tc_u_hnode, which has no tcf_result member, this results in a
slab-out-of-bounds read of res->classid in tc_cls_bind_class().
The issue can be reproduced with the following commands:
tc qdisc add dev lo root handle 1: hfsc
tc class add dev lo parent 1: classid 1:1 hfsc sc rate 1000kbit
tc filter add dev lo parent 1:1 protocol ip prio 1 u32 match u32 0 0 flowid 1:1
tc class add dev lo parent 1: classid 1:2 hfsc sc rate 2000kbit
Fix this by skipping hash tables via the TC_U32_KEY(handle) check. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: ti: am65-cpsw-nuss: Fix port_id extraction from SRC TAG
On the packet reception path, the ID of the MAC Port on which the packet
was received, is embedded in the RX DMA Descriptor's metadata. The ID is
extracted using the helper function cppi5_desc_get_tags_ids() which fills
in the 16-bit Source Tag into the 'port_id' variable. However, it is only
the lower 8-bits of the 16-bit Source Tag that represent the MAC Port ID,
while the upper 8-bits are Hardware-Reserved and carry an arbitrary value.
With the existing logic, sporadic kernel crash is observed due to the
subsequent driver code accessing out-of-bound memory because of an invalid
port_id.
Hence, fix the port_id extraction logic to use only the lower 8-bits of the
Source Tag as the MAC Port ID. |
| In the Linux kernel, the following vulnerability has been resolved:
l2tp: fix tunnel and session refcount leak on seq_file release
In pppol2tp_proc_open() and l2tp_dfs_seq_open(), iteration state
(pd->tunnel and pd->session) is kept in seq_file private data to allow
iteration across multiple read() system calls.
However, if userspace closes /proc/net/pppol2tp or /sys/kernel/debug/l2tp/tunnels
before reading to end-of-file (EOF), any tunnel or session reference stored in
pd->tunnel / pd->session is left un-dropped when seq_file private data is freed.
Fix this by dropping any remaining pd->tunnel and pd->session references in
pppol2tp_proc_release() and l2tp_dfs_seq_release() when closing the file. |
| BlueZ sdp-xml.c type confusion via RegisterProfile(ServiceRecord) can crash bluetoothd (local DoS): a crafted nested ServiceRecord can corrupt the SDP XML parser stack so scalar union data is treated as a sequence pointer, allowing a local caller to crash bluetoothd. |
| The Royal Addons for Elementor WordPress plugin before 1.7.1066 does not perform any capability or nonce check before returning taxonomy term data for an arbitrary, caller-supplied taxonomy, allowing unauthenticated users to disclose the names and IDs of terms belonging to non-public taxonomies. |
| A vulnerability was identified in code-projects Simple Inventory System 1.0. This vulnerability affects unknown code of the file /InventoryManagement/edit.php. The manipulation of the argument ID leads to sql injection. The attack is possible to be carried out remotely. The exploit is publicly available and might be used. |
| IBM PowerVM Hypervisor FW1110.00 through FW1110.20, FW1060.00 through FW1060.71, and FW950.00 through FW950.H1 A carefully crafted OS hypervisor call can cause the PowerVM hypervisor to crash or compromise OS memory integrity. |
| Faktory is a language-agnostic background job server. In versions prior to 1.10.0, the server is vulnerable to an unauthenticated denial of service in which a single malformed command crashes the entire process. Its wire protocol is line-based, and several command handlers slice or index the received line at a fixed offset, such as cmd[5:] for PUSH or qs[0] for QUEUE, without checking that a payload is present. Sending a bare verb with no payload, for example PUSH, ACK, FAIL, BEAT, PUSHB, or QUEUE, triggers a Go slice or index out-of-range panic. Because the codebase has no recover() anywhere in the command-dispatch path, an unrecovered panic in a handler goroutine terminates the whole Go process rather than just that connection, instantly disconnecting every other client, worker, and in-flight job. The attack requires only a connection to the command port and completion of the trivial handshake, with no credentials when no password is configured, and can be repeated to keep the service down indefinitely. This issue is fixed in version 1.10.0. |
| A malicious actor with access to the network could exploit an Improper Input Validation vulnerability found in UniFi Talk Application to execute a Command Injection on the host device. |
| IBM OPENBMC FW1110.00 through FW1110.20, and FW1060.00 through FW1060.71 allows a user to supply a password with a resource dump request stores that password into the BMC audit log where an admin user can see it. |
| Improper Neutralization of Input During Web Page Generation ("Cross-site Scripting") vulnerability in Drupal Search API Autocomplete allows Reflected XSS. This issue affects Search API Autocomplete versions: from 0.0.0 to 1.12.0. |
| Improper Neutralization of Input During Web Page Generation ("Cross-site Scripting") vulnerability in Drupal Media Folders allows Stored XSS. This issue affects Media Folders versions: from 0.0.0 to 1.0.8. |
| Out of bounds write in ANGLE in Google Chrome prior to 152.0.7977.65 allowed a remote attacker to execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: Medium) |
| LogTape is an unobtrusive logging library. Prior to 1.3.11, 2.0.14, and 2.1.5, the @logtape/syslog package's escapeStructuredDataValue() function in packages/syslog/src/syslog.ts does not neutralize C0 control characters from U+0000 through U+001F in structured data values, and formatStructuredData() inserts property keys without validating the RFC 5424 SD-NAME grammar. When includeStructuredData is true, an attacker-controlled newline can terminate an RFC 6587 non-transparent TCP syslog frame and make following bytes appear as a forged RFC 5424 record, while a key containing a closing bracket or other forbidden character can terminate or corrupt the structured-data element. Applications that forward attacker-controlled property values or keys can therefore allow forged records with arbitrary hosts, applications, process identifiers, facilities, or severity levels, undermining downstream collector and SIEM integrity. This issue is fixed in versions 1.3.11, 2.0.14, and 2.1.5. |
