| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
drm/dp/mst: fix buffer overflows in sideband chunk accumulation
drm_dp_sideband_append_payload() has three related bugs when processing
device-provided sideband reply data:
1. Zero-length curchunk_len underflow: msg_len is a 6-bit field taken
directly from the DP sideband header. If a device sends msg_len=0,
curchunk_len is set to zero. The condition (curchunk_idx >= curchunk_len)
is immediately true, and curchunk_len-1 wraps to 255 (u8 underflow).
drm_dp_msg_data_crc4() reads 255 bytes from chunk[48], then memcpy()
writes 255 bytes into msg[], both far out of bounds.
2. chunk[48] overflow: curchunk_len can reach 63 (6-bit field). chunk[] is
only 48 bytes. Multi-iteration payload assembly appends 16-byte blocks
until curchunk_idx reaches curchunk_len, writing up to 15 bytes past
the end of chunk[] into msg[].
3. msg[256] overflow: each chunk contributes (curchunk_len-1) bytes to
msg[]. No check ensures curlen + (curchunk_len-1) stays within msg[256],
so the memcpy can spill into adjacent struct fields.
All three are reachable from any DP MST device that can forge sideband
reply messages on a physical connection. |
| In the Linux kernel, the following vulnerability has been resolved:
tls: rx: restore msg_iter before TLS 1.3 optimistic retry
tls_decrypt_sg() advances msg->msg_iter when it maps user pages for
the optimistic TLS 1.3 zero-copy path. If the decrypted record turns
out not to be unpadded application data, tls_decrypt_sw() retries into
a kernel skb, but leaves the iterator advanced.
The subsequent copy from the skb then writes decrypted bytes again at
a later point in the caller iovecs while recvmsg() reports only the
post-retry length. A TLS peer can trigger this after the receiver
enables TLS_RX_EXPECT_NO_PAD.
Revert the iterator by the number of bytes consumed by the optimistic
mapping before retrying without zero-copy.
Add a selftest which sends a TLS 1.3 control record with
TLS_RX_EXPECT_NO_PAD enabled and verifies that recvmsg() does not
overwrite later iovecs beyond the returned length. |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: avoid out-of-bounds write in ip_vs_nat_icmp
Sashiko warns that local attacker can modify the packet
while it is processed by IPVS. Some places read the
IP ihl field multiple times which can cause out-of-bounds
access. One such place is ip_vs_nat_icmp where we
can write after the validated area.
Fix it by providing ciph argument just like it is done for
IPv6 and use ciph->len as offset to the embedded transport
header.
Modify some IPv4 header checks by reading the ihl field
only once. |
| hashcat contains a heap-based buffer overflow (out-of-bounds write) in the outfile_write() function in src/outfile.c. When assembling output into a fixed-size buffer (HCBUFSIZ_LARGE, ~16 MB), the function sequentially appends the username, separator, hash, and plaintext via memcpy without validating that the accumulated length stays within the buffer capacity. When run with --username --show against a crafted hash file containing an oversized username that nearly fills the buffer, the total assembled output exceeds the buffer, causing a heap buffer overflow that can corrupt memory and crash the process. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs3: bound to_move in indx_insert_into_root before hdr_insert_head
indx_insert_into_root() promotes a full resident $INDEX_ROOT into
$INDEX_ALLOCATION and copies all non-last resident root entries into
a newly allocated INDEX_BUFFER via hdr_insert_head(). The source
byte count 'to_move' is summed from the on-disk resident entry sizes
and is independent of the destination buffer size, which comes from
root->index_block_size (via indx->index_bits).
A crafted NTFS image that keeps a valid, full resident root but
shrinks root->index_block_size down to 512 after the root has been
populated makes hdr_insert_head() memcpy attacker-controlled resident
entry bytes past the end of the kmalloc(1u << indx->index_bits)
allocation returned by indx_new(). For a 512-byte destination and a
resident root whose non-last entries total 560 bytes, the memcpy
overruns by 120 bytes and a following memmove extends the highest
written offset to 136 bytes past the allocation. The overflow bytes
are a direct copy of on-disk entries (via kmemdup), so they are
fully attacker-controlled.
The write is reachable from unprivileged open(O_CREAT) on a mounted
crafted NTFS image: a single sufficiently long create in a directory
whose resident root is already full forces root promotion and
triggers the copy.
This is a controlled out-of-bounds write of 120-136 bytes past a
kmalloc(index_block_size) allocation, with attacker-controlled
content. It is a bounded adjacent-heap corruption primitive; it is
not an arbitrary-address write. Successful exploitation into a named
victim object depends on the surrounding slab layout.
Reject the copy at the sink. The destination's INDEX_HDR already
reports hdr_total (the payload capacity of the new buffer) and
hdr_used (the bytes already consumed by the terminal END entry
installed by indx_new()); require that to_move fits in the remaining
payload before calling hdr_insert_head(). On mismatch, fail with
-EINVAL and mark the filesystem as having a detected on-disk
inconsistency, which is the same behaviour as the surrounding
validation in this function. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: sm501fb: Fix buffer errors in OF binding code
The code that gets the frame buffer mode from OF has 'use after free',
'buffer overrun' and memory leaks.
info->edid_data isn't free if the probe functions fail or if
pd->def_mode is set.
If both the CRT and PANEL are enabled info->edid_data is used after
being freed and is freed twice.
The string returned by of_get_property(np, "mode", &len) is just
written over either the static "640x480-16@60" or the module parameter
string without any regard for the length (which is most likely longer).
Use kstrump() for the OF mode and free everything before freeing 'info. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Bound synthetic-field strings with seq_buf
The synthetic field helpers build a prefixed synthetic variable name and
a generated hist command in fixed MAX_FILTER_STR_VAL buffers. The
current code appends those strings with raw strcat(), so long key lists,
field names, or saved filters can run past the end of the staging
buffers.
Build both strings with seq_buf and propagate -E2BIG if either the
synthetic variable name or the generated command exceeds
MAX_FILTER_STR_VAL. This keeps the existing tracing-side limit while
using the helper intended for bounded command construction.
[ sdr: Moved struct seq_buf *s for upside-down x-mas tree formatting ] |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: sun4i-ss - Remove insecure and unused rng_alg
Remove sun4i_ss_rng, as it is insecure and unused:
- It has multiple vulnerabilities. sun4i_ss_prng_seed() is missing
locking and has a buffer overflow. sun4i_ss_prng_generate() fails to
fill the entire buffer with cryptographic random bytes, because it
rounds the destination length down and also doesn't actually wait for
the hardware to be ready before pulling bytes from it.
- No user of this code is known. It's usable only theoretically via the
"rng" algorithm type of AF_ALG. But userspace actually just uses the
actual Linux RNG (/dev/random etc) instead. And rng_algs don't
contribute entropy to the actual Linux RNG either. (This may have
been confused with hwrng, which does contribute entropy.)
The sun4i_ss_prng_seed() buffer overflow was reported by Tianchu Chen
and discovered by Atuin - Automated Vulnerability Discovery Engine
There's no point in fixing all these vulnerabilities individually when
this is unused code, so let's just remove it. |
| In the Linux kernel, the following vulnerability has been resolved:
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
The wait and bulk receive paths walk variable-length commands from a
USB buffer. A nonzero command shorter than CMD_HEADER_LEN can still be
dispatched, and the wait path copies a matching command into a fixed
caller-owned struct kvaser_cmd using the device-provided length.
Reject nonzero commands that do not contain the fixed header or that
extend beyond the current USB buffer item. In the wait path, also reject
a matching command that exceeds the destination before copying it. |
| NVIDIA Cumulus Linux contains a vulnerability in the Link Layer Discovery Protocol (LLDP) daemon component, where an unauthenticated attacker on an adjacent network could cause buffer overflow by sending crafted LLDP frames. A successful exploit of this vulnerability might lead to code execution. |
| Sony XAV-9500ES RTSP SETUP Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows network-adjacent attackers to execute arbitrary code on affected installations of Sony XAV-9500ES devices. Authentication is not required to exploit this vulnerability.
The specific flaw exists within the handling of SETUP RTSP packets. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a fixed-length buffer. An attacker can leverage this vulnerability to execute code in the context of the device. Was ZDI-CAN-29042. |
| Sony XAV-9500ES gpsd Buffer Overflow Arbitrary Code Execution Vulnerability. This vulnerability allows physically present attackers to execute arbitrary code on affected installations of Sony XAV-9500ES devices. Authentication is not required to exploit this vulnerability.
The specific flaw exists within the handling of NMEA data by the gpsd daemon. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a fixed-length buffer. An attacker can leverage this in conjunction with other vulnerabilities to execute code in the context of the gpsd daemon. Was ZDI-CAN-29060. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a buffer overflow. |
| GIMP TIF File Parsing Stack-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GIMP. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of TIF files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a stack-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-29399. |
| GIMP TIF File Parsing Heap-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GIMP. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of TIF files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a heap-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-29398. |
| GStreamer PNG File Parsing Heap-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GStreamer. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of PNG files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a heap-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-29581. |
| GStreamer OGG File Parsing Stack-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GStreamer. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of OGG files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a stack-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-29584. |
| GStreamer MRF File Parsing Heap-based Buffer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of GStreamer. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of MRF files. The issue results from the lack of proper validation of the length of user-supplied data prior to copying it to a heap-based buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-29608. |
| Vulnerability in NetScaler ADC and NetScaler Gateway.
This issue affects ADC: from 14.1 through 73.32 and from 13.1 through 63.21; Gateway: from 14.1 through 73.32 and from 13.1 through 63.21. |
| Buffer overflow in Dawn in Google Chrome on on Android prior to 151.0.7922.169 allowed a remote attacker to execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: Critical) |
