{"dataType": "CVE_RECORD", "dataVersion": "5.2", "cveMetadata": {"cveId": "CVE-2026-79978", "assignerOrgId": "e2e69745-5e70-4e92-8431-deb5529a81ad", "state": "PUBLISHED", "assignerShortName": "zephyr", "dateReserved": "2026-08-25T16:06:30.868Z", "datePublished": "2026-10-23T19:56:14.995Z", "dateUpdated": "2026-10-23T19:56:14.995Z"}, "containers": {"cna": {"providerMetadata": {"orgId": "e2e69745-5e70-4e92-8431-deb5529a81ad", "shortName": "zephyr", "dateUpdated": "2026-10-23T19:56:14.995Z"}, "title": "Out-of-bounds write in the ADXL345 sensor driver RTIO streaming FIFO read path", "descriptions": [{"lang": "en", "value": "The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.\n\nA short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) \u2014 for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation \u2014 takes this path whenever the pool is fragmented or the consuming thread falls behind.\n\nThe out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code."}], "affected": [{"vendor": "zephyrproject", "product": "zephyr", "collectionURL": "https://github.com/zephyrproject-rtos/zephyr", "packageName": "zephyr", "defaultStatus": "unaffected", "programFiles": ["drivers/sensor/adi/adxl345/adxl345_stream.c"], "programRoutines": [{"name": "adxl345_process_fifo_samples_cb"}], "versions": [{"version": "4.0.0", "status": "affected", "versionType": "semver", "lessThanOrEqual": "4.4.2"}]}], "references": [{"url": "https://github.com/zephyrproject-rtos/zephyr/commit/3451bb1e1e9165844060551164adb8a756e7b6b7", "name": "Fix commit", "tags": ["patch"]}, {"url": "https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-4v56-r4qm-v964", "name": "GHSA-4v56-r4qm-v964"}], "metrics": [{"format": "CVSS", "cvssV3_1": {"version": "3.1", "vectorString": "CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:L/A:L", "baseScore": 3.6, "baseSeverity": "LOW"}}], "problemTypes": [{"descriptions": [{"lang": "en", "description": "bounds", "cweId": "CWE-787", "type": "CWE"}]}], "x_generator": {"engine": "cvelib 1.8.0"}}}}

{}

{"affected": [{"affectedData": [{"collectionURL": "https://github.com/zephyrproject-rtos/zephyr", "defaultStatus": "unaffected", "packageName": "zephyr", "product": "zephyr", "programFiles": ["drivers/sensor/adi/adxl345/adxl345_stream.c"], "programRoutines": [{"name": "adxl345_process_fifo_samples_cb"}], "vendor": "zephyrproject", "versions": [{"lessThanOrEqual": "4.4.2", "status": "affected", "version": "4.0.0", "versionType": "semver"}]}], "source": "vulnerabilities@zephyrproject.org"}], "cveTags": [], "descriptions": [{"lang": "en", "value": "The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.\n\nA short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) \u2014 for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation \u2014 takes this path whenever the pool is fragmented or the consuming thread falls behind.\n\nThe out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code."}], "id": "CVE-2026-79978", "lastModified": "2026-10-23T20:17:27.657", "metrics": {"cvssMetricV31": [{"cvssData": {"attackComplexity": "HIGH", "attackVector": "LOCAL", "availabilityImpact": "LOW", "baseScore": 3.6, "baseSeverity": "LOW", "confidentialityImpact": "NONE", "integrityImpact": "LOW", "privilegesRequired": "LOW", "scope": "UNCHANGED", "userInteraction": "NONE", "vectorString": "CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:N/I:L/A:L", "version": "3.1"}, "exploitabilityScore": 1.0, "impactScore": 2.5, "source": "vulnerabilities@zephyrproject.org", "type": "Secondary"}]}, "published": "2026-10-23T20:17:27.657", "references": [{"source": "vulnerabilities@zephyrproject.org", "url": "https://github.com/zephyrproject-rtos/zephyr/commit/3451bb1e1e9165844060551164adb8a756e7b6b7"}, {"source": "vulnerabilities@zephyrproject.org", "url": "https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-4v56-r4qm-v964"}], "sourceIdentifier": "vulnerabilities@zephyrproject.org", "vulnStatus": "Received", "weaknesses": [{"description": [{"lang": "en", "value": "CWE-787"}], "source": "vulnerabilities@zephyrproject.org", "type": "Secondary"}]}

{}

{"affected": [{"configurations": [{"platform": null, "status": "affected", "versions": {"scheme": "semver", "value": "[4.0.0,4.4.2]"}}], "enrichment": {"confidence": 100.0, "confidence_source": "matching", "scores": [{"score": 100.0, "source": "matching"}]}, "original": {"product": "zephyr", "source": "cna", "vendor": "zephyrproject"}, "product": "zephyr", "vendor": "zephyrproject"}], "created": "2026-10-23T21:45:14.445404+00:00", "updated": "2026-10-23T23:15:06.944069+00:00", "vendors": ["zephyrproject", "zephyrproject$PRODUCT$zephyr"], "weaknesses": ["CWE-787"]}