| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: qcom: reject stream disable with no active interface
handle_uaudio_stream_req() resolves an interface index with
info_idx_from_ifnum(), which returns -EINVAL when no interface matches.
The enable branch and the response: cleanup label both guard against a
negative index, but the disable branch does not: it forms
info = &uadev[pcm_card_num].info[info_idx] and dereferences it.
uadev[].info is a pointer allocated only when a stream is first enabled,
so a negative info_idx on the disable path is unsafe in two ways:
- If the card was never enabled, .info is NULL and &info[-EINVAL] is a
wild pointer; reading info->data_ep_pipe faults (kernel oops).
- If the card was enabled at least once (.info allocated) and the
disable names an interface that does not match, &info[-EINVAL] points
before the allocation; info->data_ep_pipe / info->sync_ep_pipe are an
out-of-bounds slab read and, when non-zero, an out-of-bounds 4-byte
write (both pipe fields are cleared to 0). That is memory corruption,
not just a NULL dereference.
The request is reachable from unprivileged local userspace over
AF_QIPCRTR. Reject a disable request with no resolved interface, matching
the guard the enable path already has. |
| In the Linux kernel, the following vulnerability has been resolved:
bnxt: fix head underflow on XDP head-grow
The xdp.py test test_xdp_native_adjst_head_grow_data crashes when run on
a bnxt machine (and also crashes in NIPA).
It seems that the bug is an underflow in bnxt_rx_multi_page_skb, which
builds the skb head:
napi_build_skb(data_ptr - bp->rx_offset, rxr->rx_page_size);
The problem with this expression is that in page mode, rx_offset is:
bp->rx_offset = NET_IP_ALIGN + XDP_PACKET_HEADROOM;
Which evaluates (at least on x86_64) to 258.
The test test_xdp_native_adjst_head_grow_data tests a case where the
head is adjusted by -256.
When this test runs, data_ptr is shifted to frag_start + 2 (where
frag_start = page_address(page) + offset).
Then, bnxt_rx_multi_page_skb is invoked and the napi_build_skb
expression subtracts 258, landing at an address before frag_start. This
could be either the previous fragment or the previous physical page when
the offset is < 256 (e.g. if the fragment started at offset 0).
When the skb is freed, the page pool fragment reference is dropped on
either the wrong page or the wrong frag of the right page. In either
case, the corrupted reference count can lead to the page being
prematurely recycled while still in use. Once (incorrectly) recycled, it
can be handed out again and on driver teardown this would result in a
double free.
The commit under fixes updated this code to handle the case where the
native page size is >= 64k, but it unintentionally broke the head grow
case.
To fix this, add an offset field to struct bnxt_sw_rx_bd, mirroring the
existing offset field in struct bnxt_sw_rx_agg_bd. Populate it on
allocation and preserve it on reuse.
In bnxt_rx_multi_page_skb, use the newly added offset field to compute
the fragment start and pass that to napi_build_skb. Adjust the layout
with skb_reserve.
There are two cases, the non-adjustment case and the adjustment case.
In both cases, the skb is built at page_address(page) + offset to
account for the case where the native page size >= 64K and skb_reserve
is called with data_ptr - (page_address(page) + offset). That
difference equals bp->rx_offset when data_ptr was not moved, or
bp->rx_offset + xdp_adjust when XDP adjusted the head.
Re-running the failing test with this commit applied causes the test to
run successfully to completion.
The other rx_skb_func implementations don't have this issue. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: bound DMA command body size against suffix pointer
vmw_cmd_dma() locates the DMA suffix at
(unsigned long) &cmd->body + header->size - sizeof(*suffix)
without checking that header->size is large enough to contain both
cmd->body and the suffix. An undersized header makes the suffix
pointer underflow back into the previous command in the bounce
buffer. The verifier later writes suffix->maximumOffset, clobbering
verified fields of an already-relocated earlier command -- a TOCTOU
on the device-visible command stream that lets one command rewrite
another's GMR id, surface id, or other authenticated fields.
Reject the command if the body is too small for the suffix to fit. |
| In Zimbra Collaboration (ZCS) before 10.1.17, weak cryptographic key generation vulnerability exists in the OnlyOffice integration. The zimbraDocumentEditingJwtSecret is generated using an insecure random number generator, resulting in insufficient entropy. An attacker who obtains a JWT signed with the generated secret may be able to recover the JWT signing secret through offline brute-force, potentially enabling JWT forgery. |
| In the Linux kernel, the following vulnerability has been resolved:
serial: qcom_geni: fix kfifo underflow when flush precedes DMA completion IRQ
When uart_flush_buffer() runs before the DMA completion IRQ is delivered,
the following race can occur (all steps serialized by uart_port_lock):
1. DMA starts: tx_remaining = N, kfifo contains N bytes
2. DMA completes in hardware; IRQ is pending but not yet delivered
3. uart_flush_buffer() acquires the port lock and calls kfifo_reset(),
making kfifo_len() = 0 while tx_remaining remains N
4. uart_flush_buffer() releases the port lock
5. DMA IRQ fires; handle_tx_dma() acquires the port lock and calls
uart_xmit_advance(uport, tx_remaining) on an empty kfifo
uart_xmit_advance() increments kfifo->out by tx_remaining. Since
kfifo_reset() already set both in and out to 0, out wraps past in,
causing kfifo_len() to return UART_XMIT_SIZE - tx_remaining. The next
start_tx_dma() call then submits a DMA transfer of stale buffer data.
Fix this by snapshotting kfifo_len() at the start of handle_tx_dma()
and skipping uart_xmit_advance() when fifo_len < tx_remaining, which
indicates the kfifo was reset by a preceding flush. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/adfs: validate nzones in adfs_validate_bblk()
Reject ADFS disc records with a zero zone count during boot block
validation, before the disc record is used.
When nzones is 0, adfs_read_map() passes it to kmalloc_array(0, ...)
which returns ZERO_SIZE_PTR, and adfs_map_layout() then writes to
dm[-1], causing an out-of-bounds write before the allocated buffer.
adfs_validate_dr0() already rejects nzones != 1 for old-format
images. Add the equivalent check to adfs_validate_bblk() for
new-format images so that a crafted image with nzones == 0 is
rejected at probe time.
Found by syzkaller. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921: fix a potential clc buffer length underflow
The buf_len is used to limit the iterations for retrieving the country
power setting and may underflow under certain conditions due to changes
in the power table in CLC.
This underflow leads to an almost infinite loop or an invalid power
setting resulting in driver initialization failure. |
| A flaw was found in libssh. The API function `ssh_get_hexa()` is vulnerable to a denial of service when processing zero-length input. This can be exploited remotely by an attacker during GSSAPI (Generic Security Service Application Program Interface) authentication if the server's logging verbosity is set to `SSH_LOG_PACKET (3)` or higher. Successful exploitation could lead to a self-Denial of Service of the per-connection daemon process. |
| Improper Finite State Machines (FSMs) in Hardware Logic for some Intel(R) Processors may allow privileged user to potentially enable denial of service via local access. |
| The anti-theft protection mechanism can be bypassed by attackers due to weak response generation algorithms for the head unit. It is possible to reveal all 32 corresponding responses by sniffing CAN traffic or by pre-calculating the values, which allow to bypass the protection.
First identified on Nissan Leaf ZE1 manufactured in 2020. |
| Improper finite state machines (FSMs) in the hardware logic in some 4th and 5th Generation Intel(R) Xeon(R) Processors may allow an authorized user to potentially enable denial of service via local access. |
| Use of a cryptographic primitive with a risky implementation in Windows Cryptographic Services allows an authorized attacker to disclose information locally. |
| Use of a cryptographic primitive with a risky implementation in Windows Cryptographic Services allows an authorized attacker to disclose information locally. |
| Improper input validation in the SMM communications buffer could allow a privileged attacker to perform an out of bounds read or write to SMRAM potentially resulting in loss of confidentiality or integrity. |
| Improper Hardware reset flow logic in the GPU GFX Hardware IP block could allow a privileged attacker in a guest virtual machine to control reset operation potentially causing host or GPU crash or reset resulting in denial of service. |
| Some end of service NETGEAR products provide "TelnetEnable" functionality, which allows a magic packet to activate telnet service on the box. |
| A flaw was found in Glib's content type parsing logic. This buffer underflow vulnerability occurs because the length of a header line is stored in a signed integer, which can lead to integer wraparound for very large inputs. This results in pointer underflow and out-of-bounds memory access. Exploitation requires a local user to install or process a specially crafted treemagic file, which can lead to local denial of service or application instability. |
| A flaw was found in the GLib Base64 encoding routine when processing very large input data. Due to incorrect use of integer types during length calculation, the library may miscalculate buffer boundaries. This can cause memory writes outside the allocated buffer. Applications that process untrusted or extremely large Base64 input using GLib may crash or behave unpredictably. |
| Parsec is a cloud-based application for cryptographically secure file sharing. In versions on the 3.x branch prior to 3.6.0, `libparsec_crypto`, a component of the Parsec application, does not check for weak order point of Curve25519 when compiled with its RustCrypto backend. In practice this means an attacker in a man-in-the-middle position would be able to provide weak order points to both parties in the Diffie-Hellman exchange, resulting in a high probability to for both parties to obtain the same shared key (hence leading to a successful SAS code exchange, misleading both parties into thinking no MITM has occurred) which is also known by the attacker. Note only Parsec web is impacted (as Parsec desktop uses `libparsec_crypto` with the libsodium backend). Version 3.6.0 of Parsec patches the issue. |
| A flaw was found in GLib, which is vulnerable to an integer overflow in the g_string_insert_unichar() function. When the position at which to insert the character is large, the position will overflow, leading to a buffer underwrite. |
