| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Multiple vulnerabilities in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should be denied to flow through an affected device. These vulnerabilities are due to a logic error that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit these vulnerabilities by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to bypass the interface ACL and access resources that would should be protected. |
| A vulnerability in the internal packet processing of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Firewalls could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper handling of certain packets when they are sent to the inspection engine. An attacker could exploit this vulnerability by sending a series of crafted packets to an affected device. A successful exploit could allow the attacker to deplete all 9,472 byte blocks on the device, resulting in traffic loss across the device or an unexpected reload of the device. If the device does not reload on its own, a manual reload of the device would be required to recover from this state. |
| A vulnerability in the CLI of Cisco FXOS Software could allow an authenticated, local attacker to create a file or overwrite any file on the filesystem of an affected device, including system files.
The vulnerability occurs because there is no validation of parameters when a specific CLI command is used. An attacker could exploit this vulnerability by authenticating to an affected device and using the command at the CLI. A successful exploit could allow the attacker to overwrite any file on the disk of the affected device, including system files. The attacker must have valid administrative credentials on the affected device to exploit this vulnerability. |
| A vulnerability in the SSL file policy implementation of Cisco Firepower Threat Defense (FTD) Software that occurs when the SSL/TLS connection is configured with a URL Category and the Snort 3 detection engine could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to unexpectedly restart. This vulnerability exists because a logic error occurs when a Snort 3 detection engine inspects an SSL/TLS connection that has either a URL Category configured on the SSL file policy or a URL Category configured on an access control policy with TLS server identity discovery enabled. Under specific, time-based constraints, an attacker could exploit this vulnerability by sending a crafted SSL/TLS connection through an affected device. A successful exploit could allow the attacker to trigger an unexpected reload of the Snort 3 detection engine, resulting in either a bypass or denial of service (DoS) condition, depending on device configuration. The Snort 3 detection engine will restart automatically. No manual intervention is required. |
| A vulnerability in the deterministic random bit generator (DRBG), also known as pseudorandom number generator (PRNG), in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software for Cisco ASA 5506-X, ASA 5508-X, and ASA 5516-X Firewalls could allow an unauthenticated, remote attacker to cause a cryptographic collision, enabling the attacker to discover the private key of an affected device. This vulnerability is due to insufficient entropy in the DRBG for the affected hardware platforms when generating cryptographic keys. An attacker could exploit this vulnerability by generating a large number of cryptographic keys on an affected device and looking for collisions with target devices. A successful exploit could allow the attacker to impersonate an affected target device or to decrypt traffic secured by an affected key that is sent to or from an affected target device. |
| A vulnerability in the remote access VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper handling of HTTPS requests. An attacker could exploit this vulnerability by sending crafted HTTPS requests to an affected system. A successful exploit could allow the attacker to cause resource exhaustion, resulting in a DoS condition. |
| A vulnerability in ICMPv6 processing of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. This vulnerability is due to improper processing of ICMPv6 messages. An attacker could exploit this vulnerability by sending crafted ICMPv6 messages to a targeted Cisco ASA or FTD system with IPv6 enabled. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in ICMPv6 inspection when configured with the Snort 2 detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the CPU of an affected device to spike to 100 percent, which could stop all traffic processing and result in a denial of service (DoS) condition. FTD management traffic is not affected by this vulnerability. This vulnerability is due to improper error checking when parsing fields within the ICMPv6 header. An attacker could exploit this vulnerability by sending a crafted ICMPv6 packet through an affected device. A successful exploit could allow the attacker to cause the device to exhaust CPU resources and stop processing traffic, resulting in a DoS condition. Note: To recover from the DoS condition, the Snort 2 Detection Engine or the Cisco FTD device may need to be restarted. |
| A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position. |
| Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass the configured policies on an affected system. This vulnerability is due to a flaw in the FTP module of the Snort detection engine. An attacker could exploit this vulnerability by sending crafted FTP traffic through an affected device. A successful exploit could allow the attacker to bypass FTP inspection and deliver a malicious payload. |
| A vulnerability in the TLS 1.3 implementation of the Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to unexpectedly restart. This vulnerability is due to a logic error in how memory allocations are handled during a TLS 1.3 session. Under specific, time-based constraints, an attacker could exploit this vulnerability by sending a crafted TLS 1.3 message sequence through an affected device. A successful exploit could allow the attacker to cause the Snort 3 detection engine to reload, resulting in a denial of service (DoS) condition. While the Snort detection engine reloads, packets going through the FTD device that are sent to the Snort detection engine will be dropped. The Snort detection engine will restart automatically. No manual intervention is required. |
| A vulnerability in the AnyConnect SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to an implementation error within the SSL/TLS session handling process that can prevent the release of a session handler under specific conditions. An attacker could exploit this vulnerability by sending crafted SSL/TLS traffic to an affected device, increasing the probability of session handler leaks. A successful exploit could allow the attacker to eventually deplete the available session handler pool, preventing new sessions from being established and causing a DoS condition. |
| A vulnerability in the SSL/TLS certificate handling of Snort 3 Detection Engine integration with Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to restart. This vulnerability is due to a logic error that occurs when an SSL/TLS certificate that is under load is accessed when it is initiating an SSL connection. Under specific, time-based constraints, an attacker could exploit this vulnerability by sending a high rate of SSL/TLS connection requests to be inspected by the Snort 3 detection engine on an affected device. A successful exploit could allow the attacker to cause the Snort 3 detection engine to reload, resulting in either a bypass or a denial of service (DoS) condition, depending on device configuration. The Snort detection engine will restart automatically. No manual intervention is required. |
| A vulnerability in the backup configuration feature of Cisco UCS Manager Software and in the configuration export feature of Cisco FXOS Software could allow an unauthenticated attacker with access to a backup file to decrypt sensitive information stored in the full state and configuration backup files. This vulnerability is due to a weakness in the encryption method used for the backup function. An attacker could exploit this vulnerability by leveraging a static key used for the backup configuration feature. A successful exploit could allow the attacker to decrypt sensitive information that is stored in full state and configuration backup files, such as local user credentials, authentication server passwords, Simple Network Management Protocol (SNMP) community names, and other credentials. |
| A vulnerability in the CLI of Cisco Firepower 4100 Series, Cisco Firepower 9300 Security Appliances, and Cisco UCS 6200, 6300, 6400, and 6500 Series Fabric Interconnects could allow an authenticated, local attacker to inject unauthorized commands. This vulnerability is due to insufficient input validation of commands supplied by the user. An attacker could exploit this vulnerability by authenticating to a device and submitting crafted input to the affected command. A successful exploit could allow the attacker to execute unauthorized commands within the CLI. An attacker with Administrator privileges could also execute arbitrary commands on the underlying operating system of Cisco UCS 6400 and 6500 Series Fabric Interconnects with root-level privileges. |
| A vulnerability in the hardware-based SSL/TLS cryptography functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Appliances could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to an implementation error within the cryptographic functions for SSL/TLS traffic processing when they are offloaded to the hardware. An attacker could exploit this vulnerability by sending a crafted stream of SSL/TLS traffic to an affected device. A successful exploit could allow the attacker to cause an unexpected error in the hardware-based cryptography engine, which could cause the device to reload. |
| A vulnerability in the handling of RSA keys on devices running Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to retrieve an RSA private key. This vulnerability is due to a logic error when the RSA key is stored in memory on a hardware platform that performs hardware-based cryptography. An attacker could exploit this vulnerability by using a Lenstra side-channel attack against the targeted device. A successful exploit could allow the attacker to retrieve the RSA private key. The following conditions may be observed on an affected device: This vulnerability will apply to approximately 5 percent of the RSA keys on a device that is running a vulnerable release of Cisco ASA Software or Cisco FTD Software; not all RSA keys are expected to be affected due to mathematical calculations applied to the RSA key. The RSA key could be valid but have specific characteristics that make it vulnerable to the potential leak of the RSA private key. If an attacker obtains the RSA private key, they could use the key to impersonate a device that is running Cisco ASA Software or Cisco FTD Software or to decrypt the device traffic. See the Indicators of Compromise section for more information on the detection of this type of RSA key. The RSA key could be malformed and invalid. A malformed RSA key is not functional, and a TLS client connection to a device that is running Cisco ASA Software or Cisco FTD Software that uses the malformed RSA key will result in a TLS signature failure, which means a vulnerable software release created an invalid RSA signature that failed verification. If an attacker obtains the RSA private key, they could use the key to impersonate a device that is running Cisco ASA Software or Cisco FTD Software or to decrypt the device traffic. |
| A vulnerability in the CLI of Cisco FXOS Software could allow an authenticated, local attacker to inject arbitrary commands that are executed with root privileges. The attacker would need to have Administrator privileges on the device. This vulnerability is due to insufficient input validation of commands supplied by the user. An attacker could exploit this vulnerability by authenticating to a device and submitting crafted input to the affected command. A successful exploit could allow the attacker to execute commands on the underlying operating system with root privileges. |
| A vulnerability in the packaging of Cisco Adaptive Security Device Manager (ASDM) images and the validation of those images by Cisco Adaptive Security Appliance (ASA) Software could allow an authenticated, remote attacker with administrative privileges to upload an ASDM image that contains malicious code to a device that is running Cisco ASA Software. This vulnerability is due to insufficient validation of the authenticity of an ASDM image during its installation on a device that is running Cisco ASA Software. An attacker could exploit this vulnerability by installing a crafted ASDM image on the device that is running Cisco ASA Software and then waiting for a targeted user to access that device using ASDM. A successful exploit could allow the attacker to execute arbitrary code on the machine of the targeted user with the privileges of that user on that machine. Notes: To successfully exploit this vulnerability, the attacker must have administrative privileges on the device that is running Cisco ASA Software. Potential targets are limited to users who manage the same device that is running Cisco ASA Software using ASDM. Cisco has released and will release software updates that address this vulnerability. |
| A vulnerability in the CLI parser of Cisco FirePOWER Software for Adaptive Security Appliance (ASA) FirePOWER module could allow an authenticated, remote attacker to execute arbitrary commands on the underlying operating system of an affected ASA FirePOWER module as the root user. This vulnerability is due to improper handling of undefined command parameters. An attacker could exploit this vulnerability by using a crafted command on the CLI or by submitting a crafted HTTPS request to the web-based management interface of the Cisco ASA that is hosting the ASA FirePOWER module. Note: To exploit this vulnerability, the attacker must have administrative access to the Cisco ASA. A user who has administrative access to a particular Cisco ASA is also expected to have administrative access to the ASA FirePOWER module that is hosted by that Cisco ASA. |
