| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix incomplete state save in rxe_requester
If a send packet is dropped by the IP layer in rxe_requester()
the call to rxe_xmit_packet() can fail with err == -EAGAIN.
To recover, the state of the wqe is restored to the state before
the packet was sent so it can be resent. However, the routines
that save and restore the state miss a significnt part of the
variable state in the wqe, the dma struct which is used to process
through the sge table. And, the state is not saved before the packet
is built which modifies the dma struct.
Under heavy stress testing with many QPs on a fast node sending
large messages to a slow node dropped packets are observed and
the resent packets are corrupted because the dma struct was not
restored. This patch fixes this behavior and allows the test cases
to succeed. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: reject auth/assoc to AP with our address
If the AP uses our own address as its MLD address or BSSID, then
clearly something's wrong. Reject such connections so we don't
try and fail later. |
| In the Linux kernel, the following vulnerability has been resolved:
ARM: dts: exynos: Use Exynos5420 compatible for the MIPI video phy
For some reason, the driver adding support for Exynos5420 MIPI phy
back in 2016 wasn't used on Exynos5420, which caused a kernel panic.
Add the proper compatible for it. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: check for station first in client probe
When probing a client, first check if we have it, and then
check for the channel context, otherwise you can trigger
the warning there easily by probing when the AP isn't even
started yet. Since a client existing means the AP is also
operating, we can then keep the warning.
Also simplify the moved code a bit. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: don't trust firmware n_channels
If the firmware sends us a corrupted MCC response with
n_channels much larger than the command response can be,
we might copy far too much (uninitialized) memory and
even crash if the n_channels is large enough to make it
run out of the one page allocated for the FW response.
Fix that by checking the lengths. Doing a < comparison
would be sufficient, but the firmware should be doing
it correctly, so check more strictly. |
| In the Linux kernel, the following vulnerability has been resolved:
cifs: Release folio lock on fscache read hit.
Under the current code, when cifs_readpage_worker is called, the call
contract is that the callee should unlock the page. This is documented
in the read_folio section of Documentation/filesystems/vfs.rst as:
> The filesystem should unlock the folio once the read has completed,
> whether it was successful or not.
Without this change, when fscache is in use and cache hit occurs during
a read, the page lock is leaked, producing the following stack on
subsequent reads (via mmap) to the page:
$ cat /proc/3890/task/12864/stack
[<0>] folio_wait_bit_common+0x124/0x350
[<0>] filemap_read_folio+0xad/0xf0
[<0>] filemap_fault+0x8b1/0xab0
[<0>] __do_fault+0x39/0x150
[<0>] do_fault+0x25c/0x3e0
[<0>] __handle_mm_fault+0x6ca/0xc70
[<0>] handle_mm_fault+0xe9/0x350
[<0>] do_user_addr_fault+0x225/0x6c0
[<0>] exc_page_fault+0x84/0x1b0
[<0>] asm_exc_page_fault+0x27/0x30
This requires a reboot to resolve; it is a deadlock.
Note however that the call to cifs_readpage_from_fscache does mark the
page clean, but does not free the folio lock. This happens in
__cifs_readpage_from_fscache on success. Releasing the lock at that
point however is not appropriate as cifs_readahead also calls
cifs_readpage_from_fscache and *does* unconditionally release the lock
after its return. This change therefore effectively makes
cifs_readpage_worker work like cifs_readahead. |
| Out-of-bounds access vulnerability in the frequency modulation module.
Impact: Successful exploitation of this vulnerability may affect availability. |
| Vulnerability of improper permission control in the print module.
Impact: Successful exploitation of this vulnerability may affect service confidentiality. |
| Permission control vulnerability in the AMS module.
Impact: Successful exploitation of this vulnerability may affect availability. |
| Vulnerability of improper criterion security check in the card module.
Impact: Successful exploitation of this vulnerability may affect service confidentiality. |
| SmarterTrack 7922 contains an information disclosure vulnerability in the Chat Management search form that reveals agent identification details. Attackers can access the vulnerable /Management/Chat/frmChatSearch.aspx endpoint to retrieve agents' first and last names along with their unique identifiers. |
| Argo Workflows is an open source container-native workflow engine for orchestrating parallel jobs on Kubernetes. In affected versions an attacker can create a workflow which produces a HTML artifact containing an HTML file that contains a script which uses XHR calls to interact with the Argo Server API. The attacker emails the deep-link to the artifact to their victim. The victim opens the link, the script starts running. As the script has access to the Argo Server API (as the victim), so may read information about the victim’s workflows, or create and delete workflows. Note the attacker must be an insider: they must have access to the same cluster as the victim and must already be able to run their own workflows. The attacker must have an understanding of the victim’s system. We have seen no evidence of this in the wild. We urge all users to upgrade to the fixed versions. |
| Weblate is a web based localization tool. In versions prior to 5.15.1, it was possible to overwrite Git configuration remotely and override some of its behavior. Version 5.15.1 fixes the issue. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject narrower access to pointer ctx fields
The following BPF program, simplified from a syzkaller repro, causes a
kernel warning:
r0 = *(u8 *)(r1 + 169);
exit;
With pointer field sk being at offset 168 in __sk_buff. This access is
detected as a narrower read in bpf_skb_is_valid_access because it
doesn't match offsetof(struct __sk_buff, sk). It is therefore allowed
and later proceeds to bpf_convert_ctx_access. Note that for the
"is_narrower_load" case in the convert_ctx_accesses(), the insn->off
is aligned, so the cnt may not be 0 because it matches the
offsetof(struct __sk_buff, sk) in the bpf_convert_ctx_access. However,
the target_size stays 0 and the verifier errors with a kernel warning:
verifier bug: error during ctx access conversion(1)
This patch fixes that to return a proper "invalid bpf_context access
off=X size=Y" error on the load instruction.
The same issue affects multiple other fields in context structures that
allow narrow access. Some other non-affected fields (for sk_msg,
sk_lookup, and sockopt) were also changed to use bpf_ctx_range_ptr for
consistency.
Note this syzkaller crash was reported in the "Closes" link below, which
used to be about a different bug, fixed in
commit fce7bd8e385a ("bpf/verifier: Handle BPF_LOAD_ACQ instructions
in insn_def_regno()"). Because syzbot somehow confused the two bugs,
the new crash and repro didn't get reported to the mailing list. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Check dce_hwseq before dereferencing it
[WHAT]
hws was checked for null earlier in dce110_blank_stream, indicating hws
can be null, and should be checked whenever it is used.
(cherry picked from commit 79db43611ff61280b6de58ce1305e0b2ecf675ad) |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: make sure that ptp_rate is not 0 before configuring EST
If the ptp_rate recorded earlier in the driver happens to be 0, this
bogus value will propagate up to EST configuration, where it will
trigger a division by 0.
Prevent this division by 0 by adding the corresponding check and error
code. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: add srng->lock for ath11k_hal_srng_* in monitor mode
ath11k_hal_srng_* should be used with srng->lock to protect srng data.
For ath11k_dp_rx_mon_dest_process() and ath11k_dp_full_mon_process_rx(),
they use ath11k_hal_srng_* for many times but never call srng->lock.
So when running (full) monitor mode, warning will occur:
RIP: 0010:ath11k_hal_srng_dst_peek+0x18/0x30 [ath11k]
Call Trace:
? ath11k_hal_srng_dst_peek+0x18/0x30 [ath11k]
ath11k_dp_rx_process_mon_status+0xc45/0x1190 [ath11k]
? idr_alloc_u32+0x97/0xd0
ath11k_dp_rx_process_mon_rings+0x32a/0x550 [ath11k]
ath11k_dp_service_srng+0x289/0x5a0 [ath11k]
ath11k_pcic_ext_grp_napi_poll+0x30/0xd0 [ath11k]
__napi_poll+0x30/0x1f0
net_rx_action+0x198/0x320
__do_softirq+0xdd/0x319
So add srng->lock for them to avoid such warnings.
Inorder to fetch the srng->lock, should change srng's definition from
'void' to 'struct hal_srng'. And initialize them elsewhere to prevent
one line of code from being too long. This is consistent with other ring
process functions, such as ath11k_dp_process_rx().
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.30
Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1 |
| In the Linux kernel, the following vulnerability has been resolved:
Revert "net/mlx5: Block entering switchdev mode with ns inconsistency"
This reverts commit 662404b24a4c4d839839ed25e3097571f5938b9b.
The revert is required due to the suspicion it is not good for anything
and cause crash. |
| In the Linux kernel, the following vulnerability has been resolved:
clk: rs9: Fix suspend/resume
Disabling the cache in commit 2ff4ba9e3702 ("clk: rs9: Fix I2C accessors")
without removing cache synchronization in resume path results in a
kernel panic as map->cache_ops is unset, due to REGCACHE_NONE.
Enable flat cache again to support resume again. num_reg_defaults_raw
is necessary to read the cache defaults from hardware. Some registers
are strapped in hardware and cannot be provided in software. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/i915: Make intel_get_crtc_new_encoder() less oopsy
The point of the WARN was to print something, not oops
straight up. Currently that is precisely what happens
if we can't find the connector for the crtc in the atomic
state. Get the dev pointer from the atomic state instead
of the potentially NULL encoder to avoid that.
(cherry picked from commit 3b6692357f70498f617ea1b31a0378070a0acf1c) |
